Guarantor: doc. Ing. Miloslav Steinbauer, Ph.D.
Students of the faculty shall be allowed to carry out such use and work on electrical equipment in the school laboratories and workshops as is appropriate to their progressively acquired professional knowledge and physical fitness, always under the supervision of a member of staff who is assigned to their professional guidance. In accordance with the Dean's directive, students are treated for their electrical qualifications in accordance with NV 194/2022 Coll. after appropriate instruction, training and examination as instructed persons (§4).
To obtain a qualification authorizing you to work in FEEC laboratories and workshops, you must:
- complete mandatory training (valid for 5 years) - in the form of distance learning
- complete a test - in the form of distance learning, possible only after completing the mandatory training
Both the self-study instruction and the test can be completed in e-learning - subject RBEZ.
Notices and information
- Time window: distance learning and testing will be available from September 15 to October 1, 2025.
General informations
- Act 250/2021 Coll. on work safety in connection with the operation of dedicatet technical equipment. Related NV:
- Government Regulation No. 190/2022 Coll. on dedicated technical electrical equipment and requirements to ensure their safety
- Government Regulation No. 194/2022 Coll. on requirements for professional competence to work on electrical equipment and for professional competence in electrical engineering - Dean's Directive No. 2/2022 Introduction to safety regulations for students.
- Information about the achieved qualification is in the BUT Information System after logging in under Student, link in the Study menu and on this page there is a list of Achieved Qualifications
- The validity period of achieved qualification is 3 years, students can check the validity in the electronic index in IS. It is the responsibility of each student to obtain the appropriate qualification and to ensure that it is renewed in a timely manner if it expires.
- Students without a valid qualification will not be allowed to participate in the laboratory exercises.
- Qualifications in safety obtained outside the FEEC are not accepted.
Mandatory Instruction and examination
- In the BUT e-learning system, find the subject RBEZ and enter it.
- If you have not yet completed the mandatory instruction, select "Self-study training".
- After successfully completing the instruction, select "Testing - §4". Then follow the instructions on the screen. The test is limited to 10 minutes. You will find out the result of the test (pass/fail) immediately after completing the test. The information about the successfully completed test is transferred to the BUT IS in batches (manually) and therefore with a delay.
Validity of the qualification
The validity of the qualification obtained during the study is limited only to the laboratories and workshops of the FEEC BUT in Brno, the certificate of this qualification or experience is not issued in any case for third parties (temporary jobs, etc.). The period of validity of each examination is 3 years, students can check the validity in the electronic index in IS. It is the responsibility of each student to obtain the appropriate electrical qualification and to ensure that it is renewed in good time if it expires.
Study materials
English presentation Presentation.pdf
